Sunster A211 12 V/24 V 2/5 kW blower motor for diesel heater

Your selected configuration: 5kW

Match producentens model, version og reservedelsnummer. Udseende alene er ikke nok til at fastslå kompatibilitet.

Vigtigt ved montering i båd

• Forbrændingsluft og udstødning skal føres sikkert til det fri.
• Udstødningen skal være gastæt og udført med marineegnede gennemføringer, isolering og afstand til brændbare materialer.
• Brændstofslange, pumpe, kabeltværsnit og sikring skal dimensioneres korrekt.
• Montér en separat, godkendt CO-alarm i opholdsområdet. En indbygget CO-funktion erstatter ikke bådens faste alarm.
• Alt-i-ét/Toolbox-modeller må ikke stå løst i en beboet kabine, medmindre hele forbrændingskredsen er permanent og gastæt ført udenfor.

Kontrollér altid den valgte variant og Sunsters aktuelle dokumentation før installation.

Sunster A211 12 V/24 V 2/5 kW blower motor for diesel heaters – function, application, and specifications

Sunster A211 12 V/24 V 2/5 kW blower motor for diesel heaters is a diesel air heater for boats, campers, vans, workshops, and other off-grid installations where fast, dry hot air is required.

⚡ Practical benefits

• Diesel-powered air heating with low 12/24 V power consumption during normal operation.
• Supplied as a complete or model-specific solution depending on the chosen variant.

⛵ Which boat size and how many m²?

The sizing is indicative for Danish autumn and winter use. Wind, outdoor temperature, glass area, ventilation, hull material, insulation, ceiling height, and duct length can significantly alter requirements. On boats with multiple cabins, air distribution and total volume should be assessed separately.

📊 Technical specifications

✅ Typically suitable for

Boats, motorhomes, campervans, vans, workshops, and off-grid installations, provided that the model, power, voltage, and installation are correctly dimensioned.

⚠️ Important for marine installation

• Combustion air and exhaust must be safely vented to the outside.
• The exhaust must be gas-tight and installed with marine-grade fittings, insulation, and clearance from combustible materials.
• Fuel line, pump, cable cross-section, and fuse must be correctly dimensioned.
• Install a separate, approved CO alarm in the living area. A built-in CO function does not replace the boat's permanent alarm.
• All-in-one/toolbox models must not be left loose in an occupied cabin unless the entire combustion circuit is permanently and gas-tightly vented outside.

Always check the selected variant and Sunster's current documentation before installation.