Y-piece with closable damper Ø60/Ø75 mm – Air distributor & Adjustable air control

Your selected configuration: Ø60

Kontrollér diameter, temperaturgrænse og varmerens krav til luftgennemstrømning. For mange snævre bøjninger kan begrænse luftmængden.

Vigtigt ved montering i båd

• Forbrændingsluft og udstødning skal føres sikkert til det fri.
• Udstødningen skal være gastæt og udført med marineegnede gennemføringer, isolering og afstand til brændbare materialer.
• Brændstofslange, pumpe, kabeltværsnit og sikring skal dimensioneres korrekt.
• Montér en separat, godkendt CO-alarm i opholdsområdet. En indbygget CO-funktion erstatter ikke bådens faste alarm.
• Alt-i-ét/Toolbox-modeller må ikke stå løst i en beboet kabine, medmindre hele forbrændingskredsen er permanent og gastæt ført udenfor.

Kontrollér altid den valgte variant og Sunsters aktuelle dokumentation før installation.

Y-piece with closable damper Ø60/Ø75 mm – Air Distributor & Adjustable Air Control – function, application, and specifications

Y-piece with closable damper Ø60/Ø75 mm – Air Distributor & Adjustable Air Control is a diesel air heater for boats, campers, vans, workshops, and other off-grid installations where fast, dry hot air is desired.

⚡ Practical Benefits

• Diesel-powered air heating with low 12/24 V power consumption during normal operation.
• Supplied as a complete or model-specific solution depending on the chosen variant.

⛵ What boat size and how many m²?

The sizing is indicative for Danish autumn and winter use. Wind, outdoor temperature, glass area, ventilation, hull material, insulation, room height, and duct length can significantly alter the requirements. For boats with multiple cabins, air distribution and total volume should be assessed separately.

📊 Technical Specifications

✅ Typically suitable for

Boats, motorhomes, campervans, vans, workshops, and off-grid installations, when the model, power, voltage, and installation are correctly dimensioned.

⚠️ Important for boat installation

• Combustion air and exhaust must be routed safely to the outside.
• The exhaust must be gas-tight and installed with marine-grade through-hull fittings, insulation, and distance from flammable materials.
• Fuel hose, pump, cable cross-section, and fuse must be dimensioned correctly.
• Install a separate, approved CO alarm in the living area. A built-in CO function does not replace the boat's fixed alarm.
• All-in-one/Toolbox models must not be left loose in an occupied cabin unless the entire combustion circuit is permanently and gas-tightly routed outside.

Always check the chosen variant and Sunster's current documentation before installation.